BWT Chlorine Multi Tab (200 gr) - 1kg

The easiest way to perfect swimming pool water

This article is currently only available on request.

Slowly soluble combination product with chlorine
On an organic basis
Active chlorine content 80 % with flocculation effect
Preventive algae (without copper sulphate)
Ideal combination product for larger swimming pools

High-quality slow-dissolving combination product with organic-based chlorine and an active chlorine content of 80 %. The various active ingredients of the 200 gr. multifunctional long-term tablet not only ensure water hygiene, but also prevent algae infestation and improve the effectiveness of the sand filter. The product is pH-neutral and thus ensures crystal-clear water quality. The different active ingredients complement each other optimally and thus keep approx. 30 m³ of swimming pool water in a visually and hygienically perfect condition. Always follow all label instructions. Always close water care products securely and keep them away from children.

Hazard warnings

Use biocidal products carefully.
Always read the label and product information before use.

Attention! Observe danger and warning notes! Keep out of reach of children!

H302 Harmful if swallowed
H319 Causes severe eye irritation
H335 May irritate the respiratory tract
H410 Very toxic to aquatic organisms with long lasting effects
EUH031 In contact with acid, emits toxic gases
According to EC directives GefStoffV

bwt-chlor-multi-tab-sicherheitsdatenblatt.pdf

Product features

Product number: 014479

Active chlorine content:	94,5 %
Algal prevention (starch):	Yes (++)
Chlorine stabilisation:	Yes
Container size:	5 kg
Depot effect:	7 days
Dosage:	1 tablet per 30 m³
Filtermaterial:	All
Flocculation (strength):	No
Poolsize in m³:	20 - 60
Pool type:	Above ground pool large, Pool
Pool water condition:	Pool algae
Skimmer:	Yes
Solubility:	Slow
Tablet size:	200 g tablet
Treatment method:	Multifunction disinfection
pH-Neutral:	Yes

For sure, the pH value is far outside the ideal range. The problem is solved with the appropriate pH correction.

No, each product is mixed separately and must also be added to the pool water separately.

The best way to measure the chlorine content is with the BWT AQA marin Pooltester 5 in 1 according to instructions

Bad chlorine odours usually occur when there is too little free chlorine (less than 0.3 mg/l) in the water. This can be remedied by replenishing the fresh water and adding virtually soluble chlorine to a free chlorine level of 0.5mg/l.